Electrical/Electronic Engineering Tech I Job Title: Electrical/Electronic Engineering Technician IFLSA Status: ExemptDepartment: R&D EngineeringReports to: Director of Research and DevelopmentSummary: Aids in the development and design of electromechanical systems. Assembles and tests components, prototypes, electrical/electronic systems and test equipment. Essential Functions and Responsibilities:Required to provide general technician support for the benefit of our electrical engineering staff; primarily including the fabrication of electrical components to be used in new product development. Assemble electronic prototypes & cable harnesses according meeting product specifications and industry quality guidelines.Work closely with electrical and mechanical engineers to develop electromechanical products and may be required to formally report product status and testing results.Other duties may be assigned.Supervisory Responsibilities: This position does not have supervisory responsibility.Qualifications: To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill and/or ability required. Reasonable accommodations may be made to enable individuals to perform the essential functions. A minimum of three or more years of electronics assembly as well as strong technical skills which allow the applicant to apply the principles of electronics. Electronic trouble shooting and problem solving skills are a must with experience in board level evaluation and repair. Proficiency with equipment such as DMMs, oscilloscopes, frequency generators, etc needed. Required to have basic skill using electrical fabrication hand tools such as crimpers, wire strippers, etc. Ability to solder through-hole and fine pitch (50 mil) surface mount components is preferred. IPC certification or willingness to learn considered a plus. Requires solid experience in soldering, troubleshooting and repairing printed circuit boards and constructing cable harnesses. Must have the ability set up and operate test equipment to evaluate the performance of developmental parts, assemblies, or systems under test. Ability to record results and present them in a clear and concise report needed. Education and/or Experience A minimum of 3 or more years of related experience preferred.Language Ability Ability to effectively present information to co-workers and management. Computer Skills Must have working knowledge of word processing, spreadsheet and email. Proficiency in ECAD software is not required, but considered a plus. Physical DemandsThe physical demands described are representative of those that must be met by an employee to successfully perform the essential functions of the job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. The employee may be asked to lift up to 10 pounds. Work EnvironmentThe work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this position. The noise level in the shop environment is usually loud and appropriate personal protective equipment should be worn at all times.When supporting production activities, appropriate personal protective equipment should be worn at all times.Disclaimer: The above job description is not intended to be an all-inclusive list of duties and standards of the position. Incumbents will follow any other instructions and perform any other related duties as assigned by their supervisor.